Start at the wall and work back to the lamp
Work backwards from the wall. A wedding gobo projector that looks wrong is usually telling you something specific: soft edges mean focus or angle, a dim image means ambient light or dirty optics, a colour cast means the filter or the gobo. Each symptom has three or four causes and only one of them is an expensive one.
- What the surface looks like and how it is lit
- Whether the image is uniformly soft or soft at one edge
- When the fault started — overnight or gradually
- Whether anything on site changed at the same time
Blur: focus, surface and lens
Blur has three causes and only one needs a new part. First, focus drift — housings expand as they warm and short throws are more sensitive than long ones. Second, an off-axis mount, where one side of the image is genuinely further away than the other and no focus setting fixes both. Third, a surface that is not flat, which scatters the image at the edges.
Dim: ambient light, output and dirty optics
Check the easy things in order: lens cleanliness, ambient light at the working hour, image size. Halving the image area doubles the brightness at the wall, which is free. Only after those should you consider a higher output model — and if you do, note that going from 20 W to 80 W is a visible but not dramatic change.
- Clean the outer window and lens
- Measure ambient light at the working hour
- Reduce the image width and re-check contrast
- Run a full duty cycle and log the housing temperature
Colour is wrong or the gobo looks damaged
If the whole image has shifted, suspect the filter; if only part has, suspect the gobo. Dichroic coatings are stable for years, but dyed glass browns under heat, and a wedding gobo projector running at the top of its range will age a cheap filter in a single season. Photograph the image against a white reference and compare it with the install photo.
It cuts out, hums or trips
Check the supply before the fixture. A wedding gobo projector on a long cable run, a shared circuit, or a supply with its protection sized for something else will misbehave in ways that look like product failure. Measure at the unit under load, not at the distribution board.
- Note when the fault occurs — at switch-on or after warm-up
- Measure the supply at the unit under load
- Check the housing temperature and ventilation
- Confirm the protective device is correctly sized
When to stop and call the manufacturer
Call the manufacturer when the fault survives the sequence: optics cleaned, focus reset at the working hour, ambient light measured, and supply checked under load. Have the model, the install date, the throw distance and a photo of the image ready — that is enough for a supplier to tell you whether it is a warranty matter or a site issue.
- Model and serial number
- Install date and daily run hours
- Throw distance and image width
- A photograph of the fault at the working hour
